Busbar processing machine spring replacement method

The working stroke of each processing unit of the bus processing machine can be conveniently adjusted to reduce processing auxiliary time and improve production efficiency. The three working stations of the machine can work at the same time, without affecting each other, greatly improving work efficiency. The spring parts of the busbar processing machine also need to be replaced after they have been used for a long time. The following small series will introduce the replacement method of the busbar processing machine spring.

    Since the algorithm is often based on one or several assumptions in the calculation process, and these assumptions are often inconsistent with the actual situation, the single-ended impedance method has a principle error that cannot be eliminated. However, the single-ended method also has its significant advantages: simple principle, easy to use, low equipment investment, and no additional communication equipment. The busbar processing machine brings certain difficulties to the selection and use of the insulating material, which is why the other characteristics of the insulating material, such as thermal stress, mechanical properties and partial discharge, are not considered at present. Dry-type transformers can be selected from different enclosures depending on the environmental characteristics and protection requirements. The IP20 protective casing is usually used to prevent solid foreign objects larger than 12mm in diameter and small animals such as rats, snakes, cats, and birds. The busbar processing causes malignant faults such as short-circuit power failure, providing a barrier for the live parts. In a three-phase transformer, each stem is wound with a primary winding and a secondary winding, which is equivalent to a single-phase transformer. The beginning of the high-voltage winding of the three-phase transformer is usually A, B, C, and the end is represented by X, Y, Z. The low voltage windings are represented by a, b, c and x, y, z. The high and low voltage windings are respectively connected in a star or triangle row. In the low-voltage winding output is a low-voltage, high-current three-phase transformer (such as electroplating transformer), reducing the wire area of ​​the low-voltage winding, the low-voltage winding also uses a six-phase star line or six opposite star line connection. Springs such as springs are susceptible to damage during use, and breakage and deformation usually occur. The method adopted by the bus processing machine is to replace it. During the replacement process, the specifications and model of the spring must be paid attention to. The specifications and models of the spring are confirmed by the color, outer diameter and length. Only when all three items are the same can be used. replace. When the die of the CNC busbar processing machine is used, the punch is prone to breakage, bending and smashing, and the punching sleeve is generally smashed. Damage to the punch and sleeve is generally replaced with parts of the same specification.